
Entry Points
What Are You Working On?
Start with the product, the system, or the technical document you need.
Recent Work
Floors We Put Down
System Process
Build the System
A finished floor is only as good as the system underneath it. Preparation, repair, primers, body coats and protection work together.
Surface preparation
Mechanical preparation of the slab to a minimum CSP 2–3 profile, with sound concrete and a clean, dry surface.
Primer
The primer bonds the system to the slab. Where moisture vapor emission is elevated, a moisture-control primer takes the place of a standard primer.
Body coat
The build layer carries color, broadcast material and decorative work, and sets the thickness of the finished floor.
Topcoat
The topcoat is the wear surface. It sets the sheen, the chemical resistance and how the finished floor holds up in service.
Technical Center
Technical Resources
Find product information, technical documents, application resources and support when you need it.
Our Story
Built by Installers. For Installers.
MatriX Products grew out of our work in the field. FloorRescue has installed concrete floors since 2005, and the Concrete & Coatings School has trained installers since 2022. We went straight to the manufacturers and chemists so installers can buy products they trust from people who do the work.
Why MatriX
Why installers choose MatriX
Installer-Focused Products
We design every MatriX product with installers in mind, from mix ratios to cure times. The goal is a simpler install, less risk on the job, and floors you're proud to hand over.
Straight Answers and Training
We don't just ship product. We back it with education and real job-site experience, and you get honest answers when you reach out.
Clear Technical Data
Every product page shows the numbers from its data sheet: mix ratio, working time, recoat, cure, moisture limit and coverage.
Better, Not Cheapest.
Every product in the MatriX line has to earn its place. We don't sell anything we wouldn't put down ourselves.






